In addition, use the antioxidant grease pack for the wire harness connectors.Įnd User: Please contact your service company.
For additional protection, install the provided foam gasket between the keypad and the back box.
For outdoor installations, use a UL Listed weatherproof back box and seal the wire entry locations with silicone and provide a drain hole. An appropriate range is typically between 48 and 52 inches on center off the floor. Mounting height can vary depending on requirements. Mounting the Keypad The keypad is designed to be flush mounted using a standard UL Listed single-gang electrical box. The 2000e/eM keypads were evaluated by UL, in Wiegand Front End mode, for use only with the IEI Hub Max II and Hub MiniMax II products used in conjunction with the Wiegand Interface Module. The locking device and all inputs and outputs are connected to the control panel. The control panel maintains the users and programming options and makes all the access control decisions. When you enter a code on the keypad it is then sent to the control panel as Wiegand card data, depending on which format you've programmed it for. Wiegand Front End Mode: In Wiegand Front End mode, a separate Wiegand Access Control panel is required. The 2000e/eM keypads were evaluated by UL, in Secured Series Front End mode, for use only with the IEI Hub Max II and Hub MiniMax II products. The locking device and all inputs and outputs are connected to the controller. The IEI Secured Series Controller maintains the users and programming options and makes all the access control decisions. Secured Series Front End Mode: In Secured Series Front End mode, an IEI Secured Series Controller is required.
The lock and all other inputs and outputs are connected directly to the keypad. In this mode, all the users and other programming options are maintained within the keypad and no additional controller is required.
Standalone Mode: By default, the keypad is programmed for Standalone Mode. Questions can also be submitted through our website at programming section for details about selecting each mode. Technical Support Service Company: To contact IEI’s Technical Support department, call 1- 80, Monday through Friday. – 22 AWG 1.0x (“1” is the major version “0” is the minor version “x” is a minor Firmware Version version, reserved for bug fixes, which is indicated with a letter, such as “a”.) Relay Contact Rating 2A 30VDC (Main & Aux) REX Input Normally Open Dry Contact Door Position Switch Input Normally Closed Dry Contact Mechanical Dimensions 4.50" H x 2.75" W x 0.60" D Environment Indoor or Outdoor Temperature Tolerance -31☏ to 151☏ (-35✬ to 66☌) Front End Cable Type Stranded and Shielded Front End Distance and Wire 1000 Ft. VDC VAC Keypad with Output 10V: 230mA 12V: 500mA Expansion Module (200030V: 390mA 24V: 700mA 8EX) Current Requirements Note: This is total maximum current (Max) including keypad and output module. Specifications Parameter Voltage Requirements Below is a brief explanation of each mode. Keypad Operating Modes 2000 Series The 2000e/2000eM keypad has three operating modes: Standalone e/eM Style Keypad Mode, Secured Series Front End Mode and Wiegand Front End Installation and Programming Guide Mode.